If the same issue occurs on a new monitor as well, then this will confirm that the original display device was not at fault and can be reinstalled. We do not recommend that you go ahead and purchase a new one, just simply replace it with a display device lying around your office or home. If none of the methods have worked thus far, we suggest that you try replacing your display device since it can be faulty. If you find that your display is still entering Sleep Mode, continue performing the following methods: Replace Display Device Power on your PC to check if the issue has been resolved.Place the modules back into the computer and close it.Blow gently onto the RAM modules to remove any eraser leftovers.Gently, the RAM contacts the tip of an eraser to remove any dust or carbon buildup.Blow air into the desktop computer using a leaf-blower to clear out any dust.Open the computer and remove the RAM module(s).Shut down your computer and unplug any power cords.We have summarized the process in a few easy steps. Therefore, we suggest that you try cleaning out your RAM module (gold) contacts. In fact, in our personal experience, this happens at least once every two years when using a desktop computer at a location with dust particles in the air. Clean RAM Modulesĭamp or dusty RAM module contacts to the motherboard are often found to be the reasons a computer is unable to forward the display signals to the display device. ![]() If the problem persists, you can also try replacing the cable with another to check if the display cable is faulty. To rule out this possibility, we suggest that you disconnect your display cable from both ends, clean out the ports, and then try reconnecting it. It may be possible that your display cable has become loose, or signal transmission is being interrupted by the carbon buildup at the connection ports. If this does not fix your problem, proceed with performing the following methods: Check All Cable Connections If your computer is in Sleep Mode, doing the above will wake it up. To confirm this, try waking up your computer by clicking your mouse buttons or pressing some keys on your keyboard. It may be possible that your computer has entered Sleep Mode where it turns off all display devices. We suggest that you perform all the tasks given in the order mentioned before you resort to an extreme solution.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |